Traps

Home

•

•

Accessories

Tips & Information

•

Suppliers

•

Sleepy Creek Trap Setter Instructions

Copyright©2005-08 by Sleepy Creek Mfg., Inc. - All Rights Reserved Website by Hawk Mountain Designs

459 Duckwall Rd., Berkeley Springs, WV 25411  •  Phone 304-258-9175  • Fax 304-258-8694

Home | Traps | Accessories | Tips | Suppliers

In this day of heavy traps and even heavier springs, some of us could use a little help. This improved Model #2 has an angle bent handle, thus allowing the trap to be set on a flat surface. These setters are made from one piece of 12 gauge steel and will fit most coil spring traps.

Model #2 Setter Instructions

Model #3 Setter Instructions

Recommended for #450 Body Grip, #455 Body Grip, #11 Long Spring & #2 Long Spring traps.

This lightweight no-rust Trap Setter weighs only 10 ounces. The Model #3 Trap Setter was designed for the junior trapper and for adults with hand problems.  For Safety reasons, please follow these directions:

The U-Clip used in setting the #11 and #2 Long Spring MUST have pinched in legs. If these legs are bent other than shown, DO NOT use. Either re-bend or buy another.

Install with the open end toward you and fully on the spring. Should the clip fly off, it will travel away from rather than toward you.

Use on the #450 and #600 Body Grip as shown.

Model #4 Setter Instructions

Maximum #1000 Body Grip (330) Maximum #4-1/2 & #5 Long Spring (4-1/2 NH)

This lightweight, no-rust Trap Setter weighs 24 ounces.  For SAFETY, .please follow these directions.

Two U-Clips are furnished.  The smaller for the SCM  #2, #3 & #4 long spring traps and the larger for the SCM #4-1/2 long spring trap. The U-Clip must have pinched in legs. If these legs are bent other than shown, DO NOT USE. Either re-bend or purchase another.

Install with the open end toward you and fully on the spring.  Should the clip fly off, it will travel away from rather than toward you.

Use on the Body Grip as shown.